FAQ

■ How to mark cylinder work piece?

When we need to mark cylinder work piece, it is better to mark in axis direction i/o in curve direction. Because in axis direction, you can simply take cylinder as a plain work piece to mark.

If you have to mark as curve direction:

1) vertical throw is over 6mm:  You have to use rotate device. This will make things quite complicated and marking efficiency very low. ----------not recommended!

2) vertical throw is below 6mm:  Order floating pin i/o normal pin from our sales. Floating pin can directly mark vertical throw below 6mm(normal pin can only allow vertical throw below 3mm). ----------recommended!

Copyright © FIXAL Marking.    Shanghai FIXAL Tools Co., Ltd.    Website: www.fixal.cn